If you want to get in touch about the kit please tweet @webboggles, otherwise you might find that it takes me a long time to reply to comments here.
Well you aren’t going to run DOOM on an 8K chip but its still capable enough to run some classics. See the Github repos, there are a few there.
I am using OSH Park to manufacture the PCBs and they are doing a great job! Purple solder mask and immersion gold finish, don’t they look good?
You will also notice that I cut a hole to fit the 15mm piezo element flush with the board. This makes it so much neater.
Ilya’s git repo: https://github.com/webboggles/AttinyArcade
Andy’s git repo: https://github.com/andyhighnumber/Attiny-Arduino-Games
Assembly step by step .pdf
Canond DSLR Remote.ino (add 940nm IR LED to piezo pads)
PCB printable .pdf Please note the sck and scl pins in this older design are swapped around, you will need to amend these in the sketch if the screen doesn’t turn on.
3D printable snap case .stl files or on Thingiverse
SSD1306 library courtesy of Tinusaur
Update 2017/01/13: Andy Jackson refactored game code to fit two games in one cketch (https://drive.google.com/drive/u/0/folders/0BxGfuaPdM4n0bjVDSjc0WEFJVTQ)
Update 2017/01/22: Awesome “Space Attack” game by Andy Jackson:
Update: 2017/02/26: Andy’s repo (Wren Rollercoaster, Space Attack, UFO Stacker, Bat Bonanza) https://drive.google.com/drive/folders/0BxGfuaPdM4n0Nkt5TDI4azd1Rmc
For soldered componenent placement refer to the assembly .pdf
New assembly video using the latest revision board.
DIY pcb assembly video: https://www.youtube.com/embed/OlJzhWNhtKA